关键词: 水工钢闸门, 面板折算应力公式, 梁整体弯曲应力, 面板局部弯曲应力, 面板设计方法

Abstract: Design Specification for Steel Gates of Water and Hydropower Projects stipulates that the main beam, as the principal load-bearing component of a hydraulic steel gate, shall be designed as an elastic structure; the water-stopping panel, which has a large strength margin, shall be designed as an elastoplastic structure that accounts for local plasticity. However, applying the plastic-elastic design for the converted stress strength of panels functioning as beam flanges is highly hazardous, particularly for high-head gates or pumped-storage gates. Based on this, this paper presents a new verification criterion for the equivalent stress strength of panels by separating the design functionally－a plastic design for the local bending strength of the panel performing water-retaining function, and an elastic design for the overall bending strength of the panel also serving as a beam flange. We derive a new formula for verifying panel equivalent stress by multiplying the equivalent stress from current codes by an expansion factor. This formula is validated through a comparative analysis of four safety verification formulas－elastic, plastic, equivalent stress, and the function-differentiated equivalent stress described in this paper. Results indicate the current code's verification method for this equivalent stress strength poses safety risks, while our new formula increases its value by 20% to 35%. Engineering case studies of two high-head flat gates verify the accuracy and rationality of the new formula, laying a basis for high-head gate design and code revision.

Key words: hydraulic steel gates, panel equivalent stress formula, beam overall bending stress, panel local bending stress, panel design methods